To determine the most proper bed, time, and wounding factors on the rooting of semi-hard cuttings of olive (Olea europaea), cuttings were selected and research was conducted at the Faculty of Agriculture of the Tehran Univ. in Karaj. The required cuttings were taken from healthy and similar mother trees at the Roodbar Research Station. Then, semi-hard cuttings of 15 cm in length and 3 to 5 mm in diameter with four terminal leaves were prepared. Then those prepared cuttings were treated with IBA at 4000 ppm and Captan fungicide at 3000 ppm before planting. This experiment was designed in a factorial with a randomized complete block, with four media bed factors for rooting in seven levels (peatmoss + perlite, sawdust + sand, peatmoss + sand, and perlite, sand, and perlite + sand), the time factor for cutting preparation in four levels (May, August, September, and March), cultivars at two levels (Roghani and Zard Zeitoun), and wounding treatment at two levels (unwounded and wounded); there were three replications (20 cuttings per replicate per each unit). The results indicate that, among the selected beds, perlite with 53% of rooting average yield has the highest and peatmoss + perlite with a rooting average of 43.8% has the lowest. As far as time is concerned, those cuttings prepared in March show the highest rooting average of 69.3%, while those prepared in August show the lowest average of 12.7%. The comparison between the two cultivars shows that Roghani, with 60.4% rooting yield, is preferred to Zard Zeitoun, with 48.2% rooting average. There were no significant differences between wounded and unwounded cuttings with regard to rooting.