The demand for groundcover plants for landscape use is increasing. Plantable containers are becoming available in sizes appropriate for groundcover plants. Landscapers are seeking ways to decrease the time required to prepare and plant groundcover beds. Studies were conducted in 2011 and 2012 to evaluate plantable containers for a variety of groundcover plants. The study has shown that ‘Bronze Beauty’ ajuga (Ajuga reptans), ‘Herman’s Pride’ lamiastrum (Lamiastrum galeobdolon), ‘Beacon Silver’ lamium (Lamium maculatum), ‘Immergrunchen sedum (Sedum hybridum), ‘Red Carpet Stonecrop’ sedum (Sedum spurium), and ‘Vera Jameson’ sedum (Sedum telephium) were grown to a marketable size from 1.5-inch plugs in 8 weeks in Lexington, KY, when transplanted in May through August. ‘Big Blue’ liriope (Liriope muscari) from bare root bibs required 12 weeks. Plant growth in a 90-mm paper container and 80-mm bioplastic container was similar to that of plants grown in standard 3-inch rigid plastic containers and required 20% less time to transplant into the landscape and grew rapidly after transplanting in the field. Peat containers in this production system yielded smaller plants and slower ground coverage after transplanting in the field than plants grown in the other containers.
Susmitha S. Nambuthiri and Dewayne L. Ingram
Susmitha Nambuthiri, Ethan Hagen, Amy Fulcher, and Robert Geneve
Two sensor-based irrigation scheduling systems were compared for water use and plant growth in container-grown Green Velvet boxwood (Buxus sempervirens L. × B. microphylla Siebold & Zucc. var. koreana ‘Green Velvet’) and slender deutzia (Deutzia gracilis Siebold & Zucc). These crops were chosen because they have different water requirements during production. The two sensor-based irrigation systems included a physiological-based on-demand (OD) irrigation system where the set point was derived from the relationship between substrate moisture and photosynthetic rate. The second system was a daily water use (DWU) method where the amount of water used by the crop was replaced each day. The objective of the study was to evaluate and compare water use and growth metrics using the OD and DWU irrigation scheduling regimes for two container-grown woody plants that differed in their water consumption. There were no differences in root and shoot biomass or growth index due to the irrigation schedule employed for either boxwood or deutzia. For boxwood plants, OD irrigation reduced water consumption by 35.5% and enhanced water use efficiency (WUE) by 54.5% compared with DWU. Total water use of deutzia in OD zones was reduced by 26.5% compared with DWU. DWU offers the labor scheduling advantage of irrigation occurring at a set time of day, and OD offers the advantage of watering as required, potentially reducing water stress as the season progresses and as the plant size and atmospheric demand increase.
Dewayne L. Ingram, Timothy A. Woods, Wuyang Hu, and Susmitha S. Nambuthiri
Increasing demand for groundcover plants and increasing consumer preference for more sustainable products encourage nursery crop producers and landscape management companies to assess efficiency and sustainable practices. Ajuga reptans ‘Bronze Beauty’ and Sedum kamtschaticum ‘Variegatum’ were grown in standard plastic containers or plantable containers (Ellepot and SoilWrap) and 12- or 18-count flats. These production alternatives were presented in personal surveys of commercial industry personnel and consumers to determine their willingness to pay for these attributes. A conjoint analysis revealed an affinity for both groups to purchase flats of groundcovers and preferred sedum over ajuga. Commercial buyers from larger companies were more likely to purchase plantable containers than those from smaller firms. Generally, flats of Ellepots were preferred over flats of SoilWraps and 18-count over 12-count flats by commercial buyers. Price had a negative impact on consumer willingness to pay. Consumers revealed no specific preference for the plantable containers, although preference for plastic containers declined with age and presence of children at home.
Susmitha Nambuthiri, Amy Fulcher, Andrew K. Koeser, Robert Geneve, and Genhua Niu
Market researchers have found that nursery and greenhouse production practices that reduce plastic use can increase consumer interest. However, there are broader crop performance, production efficiency, and environmental factors that must be considered before adopting containers made with alternative materials. This review highlights current commercially available alternative containers and parent materials. In addition, findings from recent and ongoing nursery, greenhouse, and landscape trials are synthesized, identifying common themes, inconsistencies, research gaps, and future research needs.
Michael R. Evans, Andrew K. Koeser, Guihong Bi, Susmitha Nambuthiri, Robert Geneve, Sarah Taylor Lovell, and J. Ryan Stewart
Nine commercially available biocontainers and a plastic control were evaluated at Fayetteville, AR, and Crystal Springs, MS, to determine the irrigation interval and total water required to grow a crop of ‘Cooler Grape’ vinca (Catharanthus roseus) with or without the use of plastic shuttle trays. Additionally, the rate at which water passed through the container wall of each container was assessed with or without the use of a shuttle tray. Slotted rice hull, coconut fiber, peat, wood fiber, dairy manure, and straw containers were constructed with water-permeable materials or had openings in the container sidewall. Such properties increased the rate of water loss compared with more impermeable bioplastic, solid rice hull, and plastic containers. This higher rate of water loss resulted in most of the biocontainers having a shorter irrigation interval and a higher water requirement than traditional plastic containers. Placing permeable biocontainers in plastic shuttle trays reduced water loss through the container walls. However, irrigation demand for these containers was still generally higher than that of the plastic control containers.
Susmitha Nambuthiri, Robert L. Geneve, Youping Sun, Xueni Wang, R. Thomas Fernandez, Genhua Niu, Guihong Bi, and Amy Fulcher
The green industry has identified the use of biodegradable containers as an alternative to plastic containers as a way to improve the sustainability of current production systems. Field trials were conducted to evaluate the performance of four types of 1-gal nursery biocontainers [keratin (KR), wood pulp (WP), fabric (FB), and coir fiber (Coir)] in comparison with standard black plastic (Plastic) containers on substrate temperature, water use, and biomass production in aboveground nurseries. Locations in Kentucky, Michigan, Mississippi, and Texas were selected to conduct experiments during May to Oct. 2012 using ‘Green Velvet’ boxwood (Buxus sempervirens × B. microphylla) and ‘Dark Knight’ bluebeard (Caryopteris ×clandonensis) in 2013. In this article, we were focusing on the impact of alternative container materials on hourly substrate temperature variations and plant growth. Substrate temperature was on an average higher (about 6 °C) in Plastic containers (about 36 °C) compared with that in WP, FB, and Coir containers. However, substrate temperature in KR containers was similar to Plastic. Substrate temperature was also influenced by local weather conditions with the highest substrate temperatures recorded in Texas followed by Kentucky, Mississippi, and Michigan. Laboratory and controlled environment trials using test containers were conducted in Kentucky to evaluate sidewall porosity and evaporation loss to confirm field observations. Substrate temperature was similar under laboratory simulation compared with field studies with the highest substrate temperature observed in Plastic and KR, intermediate in WP and lowest in FB and Coir. Side wall temperature was higher in Plastic, KR, and FB compared with WP and Coir, while side wall water loss was greatest in FB, intermediate in WP and Coir, and lowest in plastic and KR. These observations suggest that the contribution of sidewall water loss to overall container evapotranspiration has a major influence on reducing substrate temperature. The porous nature of some of the alternative containers increased water use, but reduced heat stress and enhanced plant survival under hot summer conditions. The greater drying rate of alterative containers especially in hot and dry locations could demand increased irrigation volume, more frequent irrigation, or both, which could adversely affect the economic and environmental sustainability of alternative containers.
Xueni Wang, R. Thomas Fernandez, Bert M. Cregg, Rafael Auras, Amy Fulcher, Diana R. Cochran, Genhua Niu, Youping Sun, Guihong Bi, Susmitha Nambuthiri, and Robert L. Geneve
Containers made from natural fiber and recycled plastic are marketed as sustainable substitutes for traditional plastic containers in the nursery industry. However, growers’ acceptance of alternative containers is limited by the lack of information on how alternative containers impact plant growth and water use (WU). We conducted experiments in Michigan, Kentucky, Tennessee, Mississippi, and Texas to test plant growth and WU in five different alternative containers under nursery condition. In 2011, ‘Roemertwo’ wintercreeper (Euonymus fortunei) were planted in three types of #1 (≈1 gal) containers 1) black plastic (plastic), 2) wood pulp (WP), and 3) recycled paper (KF). In 2012, ‘Green Velvet’ boxwood (Buxus sempervirens × B. microphylla siebold var. koreana) was evaluated in 1) plastic, 2) WP, 3) fabric (FB), and 4) keratin (KT). In 2013, ‘Dark Knight’ bluebeard (Caryopteris ×clandonensis) was evaluated in 1) plastic, 2) WP, and 3) coir fiber (Coir). Plants grown in alternative containers generally had similar plant growth as plastic containers. ‘Roemertwo’ wintercreeper had high mortality while overwintering in alternative containers with no irrigation. Results from different states generally show plants grown in fiber containers such as WP, FB, and Coir used more water than those in plastic containers. Water use efficiency of plants grown in alternative containers vs. plastic containers depended on plant variety, container type, and climate.
Tongyin Li, Guihong Bi, Genhua Niu, Susmitha S. Nambuthiri, Robert L. Geneve, Xueni Wang, R. Thomas Fernandez, Youping Sun, and Xiaojie Zhao
The performance of biocontainers as sustainable alternatives to the traditional petroleum-based plastic containers has been researched in recent years due to increasing environmental concern generated by widespread plastic disposal from green industry. However, research has been mainly focused on using biocontainers in short-term greenhouse production of bedding plants, with limited research investigating the use of biocontainers in long-term nursery production of woody crops. This project investigated the feasibility of using biocontainers in a pot-in-pot (PIP) nursery production system. Two paper (also referred as wood pulp) biocontainers were evaluated in comparison with a plastic container in a PIP system for 2 years at four locations (Holt, MI; Lexington, KY; Crystal Springs, MS; El Paso, TX). One-year-old river birch (Betula nigra) liners were used in this study. Results showed that biocontainers stayed intact at the end of the first growing season, but were penetrated to different degrees after the second growing season depending on the vigor of root growth at a given location and pot type. Plants showed different growth rates at different locations. However, at a given location, there were no differences in plant growth index (PGI) or plant biomass among plants grown in different container types. Daily water use (DWU) was not influenced by container type. Results suggest that both biocontainers tested have the potential to be alternatives to plastic containers for short-term (1 year) birch production in the PIP system. However, they may not be suitable for long-term (more than 1 year) PIP production due to root penetration at the end of the second growing season.
Robin G. Brumfield, Alyssa J. DeVincentis, Xueni Wang, R. Thomas Fernandez, Susmitha Nambuthiri, Robert L. Geneve, Andrew K. Koeser, Guihong Bi, Tongyin Li, Youping Sun, Genhua Niu, Diana Cochran, Amy Fulcher, and J. Ryan Stewart
As high-input systems, plant production facilities for liner and container plants use large quantities of water, fertilizers, chemical pesticides, plastics, and labor. The use of renewable and biodegradable inputs for growing aesthetically pleasing and healthy plants could potentially improve the economic, environmental, and social sustainability of current production systems. However, costs for production components to integrate sustainable practices into established systems have not been fully explored to date. Our objectives were to determine the economic costs of commercial production systems using alternative containers in aboveground nursery systems. We determined the cost of production (COP) budgets for two woody plant species grown in several locations across the United States. Plants were grown in plastic pots and various alternative pots made from wood pulp (WP), fabric (FB), keratin (KT), and coconut fiber (coir). Cost of production inputs for aboveground nursery systems included the plant itself (liner), liner shipping costs, pot, pot shipping costs, substrate, substrate shipping costs, municipal water, and labor. Our results show that the main difference in the COP is the price of the pot. Although alternative containers could potentially increase water demands, water is currently an insignificant cost in relation to the entire production process. Use of alternative containers could reduce the carbon, water, and chemical footprints of nurseries and greenhouses; however, the cost of alternative containers must become more competitive with plastic to make them an acceptable routine choice for commercial growers.