Sweetpotato is an important crop worldwide, valued at over $9.4 billion (Food and Agriculture Organization of the United Nations, 2012). In the United States, sweetpotato production is valued at $698 million in gross farm value [U.S. Department of Agriculture (USDA), 2015a]. North Carolina ranks first in sweetpotato production in the United States with 73,000 acres planted in 2014, which accounts for more than half of the total acreage planted nationwide (USDA, 2015b). ‘Covington’ sweetpotato, released by the North Carolina Agricultural Research Service in 2005, accounts for 88% of certified seed root acreage in North Carolina, followed by ‘Beauregard’ and ‘Evangeline’ at 5% and 3%, respectively (North Carolina Crop Improvement Association, 2014; Yencho et al., 2008). ‘Evangeline’ sweetpotato was released by the Louisiana Agricultural Experiment Station in 2007 and was reported to have southern root-knot nematode (Meloidogyne incognita) resistance, yields that are comparable to ‘Beauregard’, and an excellent flavor profile (La Bonte et al., 2008). In addition to ‘Covington’, ‘Evangeline’ under North Carolina growing conditions had been minimally investigated in terms of production practices and was, therefore, considered an important component in the study.
A sweetpotato crop is established with nonrooted cuttings (slips), which are vegetatively produced in field propagation beds. North Carolina growers use a wide (24 to 73 bu/1000 ft2) range of seed root densities to produce sweetpotato slips (D. Godwin, D. Scott, and J. Jones, personal communication). However, a lack of knowledge exists on what is the optimum seed root density and size for production of sweetpotato slips. Depending on grower’s equipment, the propagation beds are elevated about 10 inches and are 36 inches wide (Wilson et al., 1977). Mainly canner size roots (1 to 1.75 inches diameter) are used as seed source for propagation beds (Smith et al., 2009). These seed roots are cured [85 °F, 85% to 90% relative humidity (RH)] for ≈1 week after harvest to heal wounds to the skin that occurs during harvest and then stored at 55 to 60 °F and 80% to 85% RH (Edmunds et al., 2008; Kemble, 2013; Steinbauer and Kushman, 1971). Before bedding, the seed roots are presprouted in storage (85 °F, 85% RH) for 20 to 28 d (Kemble, 2013). Sweetpotato seed roots are placed into the propagation beds and then covered with 2 inches of soil (Wilson et al., 1977). Clear polyethylene mulch is then placed over the beds to increase the soil temperature and facilitate sprouting. Mulch is vented after 7 d to prevent an accumulation of carbon dioxide and then removed completely once shoot emergence begins and before bed temperatures become too hot. Once slips reach optimal size (7 to 14 inches), they are cut either by hand or with mechanical cutters, and packed in boxes (1000 slips/box) to transport and plant directly into the production field (Smith et al., 2009). Many commercial growers in North Carolina adopt a once-over harvest strategy, meaning that only one cutting is obtained from slip propagation beds. However, there are some growers that cut slips multiple times, coming back when slips have regrown to optimal size. Adopting a multiple harvest slip production strategy is common in geographical locations that have longer sweetpotato-growing seasons. Australian growers can harvest seedbed cuttings at least four to five times with 4 weeks between harvests (Northern Territory Government, 2005).
At the end of the growing season, when storage roots are harvested, a portion of the roots are saved to use as seed roots for the following year. This process is repeated for a number of years, each of which is called a generation (G). However, clones can slowly decline over each generation due to the accumulation of viruses, pathogens, and mutations (Clark et al., 2002; Villordon and LaBonte, 1996). Therefore, it is recommended to use no older than G-5 (the number indicates number of years in field production) seed root stock (Bryan et al., 2003).
Research is lacking with respect to documenting the effects of sweetpotato seed root density and size on transplant yield and quality. Thus, the primary objective of this research was to identify optimal seed root density and size of ‘Covington’ and ‘Evangeline’ that maximize production and quality of slips and return on investment. This project was conducted in direct response to grower interest and with sweetpotato industry funding.
Bryan, A.D., Pesic-VanEsbroeck, Z., Schultheis, J.R., Pecota, K.V., Swallow, W.H. & Yencho, G.C. 2003 Cultivar decline in sweetpotato: I. Impact of micropropagation on yield, storage root quality, and virus incidence in ‘Beauregard’ J. Amer. Soc. Hort. Sci. 128 846 855
Clark, C.A., Valverde, R.A., Fuentes, S., Salazar, L.F. & Moyer, J.W. 2002 Research for improved management of sweetpotato pests and diseases: Cultivar decline Acta Hort. 583 103 112
Edmunds, B.A., Boyette, M.D., Clark, C.A., Ferrin, D.M., Smith, T.P. & Holmes, G.J. 2008 Postharvest handling of sweetpotatoes. North Carolina Coop. Ext. Serv. AG-413-10-B
Food and Agriculture Organization of the United Nations 2012 Food and agriculture organization statistical yearbook 2012. 22 Apr. 2014. <http://www.fao.org/docrep/015/i2490e/i2490e00.htm>
Granberry, D.M., Colditz, P. & McLaurin, W.J. 1986 Sweet potato. Georgia Ext. Bul. 677
Jilani, M.S., Khan, M.Q. & Rahman, S. 2009 Planting densities effect on yield and yield components of onion (Allium cepa L.) J. Agr. Res. 47 397 404
Kemble, J.M. 2013 2013 Southeastern U.S. vegetable crop handbook. Vance Publ., Lincolnshire, IL
North Carolina Crop Improvement Association 2014 Seed list 2013–2014. 22 Apr. 2014. <http://www.nccrop.com/files/2013-2014%20SEED%20LIST%20%28winter%29.pdf>
Northern Territory Government 2005 Sweet potato production guide for the top end. 28 Feb. 2015. <http://www.nt.gov.au/d/Content/File/p/Vegetable/IB1.pdf>
Oliveira, A. dos S., de Carvalho, M.L.M., Nery, M.C., Oliveira, J.A. & Guimarães, R.M. 2011 Seed quality and optimal spatial arrangement of fodder radish Sci. Agr. 68 417 423
Rodriguez, N.F. & Sanchez de Bustamante, C.A. 1963 Importance of type of cutting for the production of cassava in Misiones Revista Investigacion Agricola Buenos Aires 17 289 302
Smith, T.P., Stoddard, S., Shankle, M. & Schultheis, J.R. 2009 The sweetpotato, p. 287–323. In: G. Loebenstein and G. Thottappilly (eds.). Sweetpotato production in the United States. Springer, Dordrecht, The Netherlands
Steinbauer, C.E. & Kushman, L.J. 1971 Curing and storage, p. 42–46. In: C.E. Steinbauer and L.J. Kushman (eds.). Sweetpotato culture and diseases. U.S. Dept. Agr., Agr. Res. Serv., Agr. Hdbk. 388
Thompson, W.B. 2014 Sweetpotato transplant establishment considerations for sweetpotato production in North Carolina. MS Thesis, North Carolina State Univ., Raleigh, NC
U.S. Department of Agriculture (USDA) 2005 United States standards for grades of sweetpotatoes. 15 Nov. 2014. <http://www.ams.usda.gov/AMSv1.0/getfile?dDocName=STELPRDC5050330>
U.S. Department of Agriculture (USDA) 2015a Crop values 2014 summary. 25 Feb. 2015. <http://usda.mannlib.cornell.edu/usda/nass/CropValuSu//2010s/2015/CropValuSu-02-24-2015_correction.pdf>
U.S. Department of Agriculture (USDA) 2015b Crop production 2014 summary. 22 Feb. 2015. <https://www.census.gov/history/pdf/cropan15.pdf>
Villordon, A.Q. & LaBonte, D.R. 1996 Genetic variation among sweetpotatoes propagated through nodal and adventitious sprouts J. Amer. Soc. Hort. Sci. 121 170 174
Wilson, L.G., Covington, H.M. & Averre, C.W. 1977 Sweetpotato production, handling, curing, storage, and marketing in North Carolina. Proc. Symp. Intl. Soc. Tropical Root Crops. p. 146–150
Wilson, S.D. & Tilman, D. 1991 Components of plant competition along an experimental gradient of nitrogen availability Ecology 72 1050 1065
Yencho, G.C., Little, B.E., Thornton, A.C., Truong, V., Holmes, G.J., Pecota, K.V., Schultheis, J.R. & VanEsbroeck, Z. 2008 ‘Covington’ sweetpotato HortScience 43 1911 1914